Multi - row powder packaging machine packaging mainly refers to the packaging of powder and other materials. Powder packaging machine - food machinery equipment network has the characteristics of high packaging efficiency, low energy consumption, quantitative packaging, high packaging quality, can well meet the quantitative high-quality packaging process needs of food processing enterprises. However, when the user actually uses the powder packaging machine, there will occasionally be some problems, such as failure to start, bag cutting position deviation, film cutting machine stuck or not rotating, material leakage, unstable display value, electromagnet does not absorb, sealing is not tight, etc.
Whether it is powder packaging equipment or other mechanical equipment, it is obvious that the packaging production line can not run normally, or even the whole production line may face the risk of shutdown. If the powder packaging equipment can not start normally, the user needs to check as soon as possible, check whether the fuse is blown because of long time work or high voltage; You can also check if the hood is closed completely, or if the compressed air pressure is insufficient and the sensor is loose.
I remember that some manufacturers reflect that when the packaging machine cuts the bag, there will often be deviation. The gap between the same color standard is too large, resulting in unsatisfactory bag cutting effect. To this, the personage inside course of study suggests the user can readjust the position of switch first. The molding device is then cleaned, the powder packaging material is inserted into the device, and its position is adjusted so that the point of light overlapped with the middle of the color code. This can avoid the problem of large bag cutting deviation to a certain extent.
Compared with the large working deviation of powder packaging equipment, the film feeder is stuck or not rotating, which is related to improper position adjustment and deviation. Of course, not only that, if the film supply control lever is stuck or not controlled, start-up failure or fuse problems can also cause the film supply machine to get stuck or not rotate. At this point, users need to troubleshoot in time, adjust the membrane control lever, replace or maintain the fuse to ensure smooth operation.
